This 2″ x 27′ strap in blue pairs heavy-duty webbing with a ratchet take-up system, giving you the mechanical advantage to secure loads that hand-tightening alone can’t match. End hardware is a compact wire hook (also called a double J-hook) built to reach narrow anchor points and D-rings. Sold as a 10-pack.
Key Features
- Heavyweight polyester webbing woven with more picks per inch than typical straps on the market, for a webbing that resists abrasion, tearing, and cutting
- Cleanly heat-sealed ends that stop fraying before it starts, extending the working life of the strap
- Slim wire hook profile that fits into tight anchor points where a bulkier hook won’t reach
- Corrosion-resistant zinc-plated hardware built for outdoor and roadside use
- Tagged and stenciled with break strength and working load limit information to support compliance with FMCSA and DOT regulations, CVSA and WSTDA guidelines, and North American cargo securement standards
Applications
- Landscaping, construction, and job-site equipment transport
- Moving and general hauling with pickup trucks and trailers
- Flatbed and open-trailer freight hauling
- Everyday towing and utility trailer use
Installation
Wrap the fixed end around the anchor point and feed the free end through the ratchet mandrel, pulling out slack by hand before ratcheting. Tighten in small increments until the load is secure, then close and lock the ratchet handle. Confirm hooks are properly seated on rated anchor points, stay within the strap’s working load limit, and re-check tension after the first few miles.
