A workhorse of the trucking and trailering world, this 2″ x 30′ ratchet strap uses a geared take-up mechanism rather than hand tension alone, so you can cinch a load down firmly and evenly. It’s finished with hardware built for fast, repeated hookup and release in the field. Sold as a 4-pack.
Key Features
- Heavyweight polyester webbing woven with more picks per inch than typical straps on the market, for a webbing that resists abrasion, tearing, and cutting
- Heat-sealed webbing ends that resist fraying so the strap keeps its finished edge over years of use
- Corrosion-resistant zinc-plated hardware built for outdoor and roadside use
- Tagged and stenciled with break strength and working load limit information to support compliance with FMCSA and DOT regulations, CVSA and WSTDA guidelines, and North American cargo securement standards
Applications
- Everyday towing and utility trailer use
- Moving and general hauling with pickup trucks and trailers
- Landscaping, construction, and job-site equipment transport
- Securing lumber, pipe, and other bundled materials
Installation
Wrap the fixed end around the anchor point and feed the free end through the ratchet mandrel, pulling out slack by hand before ratcheting. Tighten in small increments until the load is secure, then close and lock the ratchet handle. Confirm hooks are properly seated on rated anchor points, stay within the strap’s working load limit, and re-check tension after the first few miles.
