- Blum Inserta half-cranked hinge bundle for back-to-back (also known as twin overlay) doors on frameless cabinets.
- Inserta hinges install on the door without using screws. On the hinge cup is a cover that acts as a lever. By pressing down on the lever, an anchor device is expanded which secures the hinge. This type of hinge is also known as a tool-free or toolless hinge.
- This hinge uses two 8mm (5/16″) holes where the wood screw holes would normally be to secure the hinge. See the document found under Downloads to view the Inserta screw hole pattern.
- The hinge and mounting plate attach to each other by snapping on.
What’s Included
- 1 x Blum Inserta Half-Cranked Hinge
- 1 x System Screw Frameless Mounting Plate
Mounting Screws
- Depending on cabinet side wall thickness you will need either of the following screws:
- For cabinet wall thickness of 5/8″ to 7/8″, you will need to use back to back mounting screws.
- For cabinet wall thickness of 1″ or greater, use 6 x 5/8″ screws.
- Note that only two back to back screws are required for two hinges, whereas you would need four 6 x 5/8″ screws for two hinges.
Available for purchase separately:
- Cover Plate for the Hinge Arm – Hides the screws on the hinge arm providing a cleaner appearance (SKU 268002)
- Soft-Close Add-On Device – Eliminates slamming of the door and dampens the closing action (SKU 268230)
- Plastic Dowels, used on manufactured wood products where wood screws do not hold well (SKU 652368)
- Restriction clip. Limits angle of opening to 86 degrees (SKU 701113)
- Blum Touch Latch for Self-Closing Doors (SKU 268822)
- 35mm Forstner Bit, for new installations (SKU 204000)
- Ecodrill, installation jig, for new installations (SKU 701000)
